PDA

View Full Version : Layer Help



Wilee Castusmaximas
07-23-2006, 03:55 AM
A lot of maps have everything drawn on layer #1 and nothing else it seems. I have heard you can adjust elevation and filter out certain heights, is this true and if so , what are the normal defaut heights to block so you can only see 1 instead of 3 in one huge mess looking like it was made by a pre-schooler.


All else fails is there a way for me to edit the 1 layer maps & split them to 3 seperate levels.

Thanks
Wilee

Fatal
07-25-2006, 10:58 PM
it depends on the zone you are in. You can go to one of those zones where evrything is overlapping, like RSS, and play with the height filters. Unfortunalty, there is no common distance between levels in EQ so every zone could be different.

Worse yet, your height filter settings are nto saved and will have to reset every time you zone.